Network Technologies ASI-IP-GTW Instrukcja Użytkownika Pobierz pdf (Strona 42)

ASI-IP-GTW User's Manual

Page 42

3.6.2 FEC Settings

Figure 17. IP TX FEC page

This sub-page will only appear if the unit is enabled with FEC.

FEC Mode: Select "No FEC" to not calculate and send any FEC data.

Select "Column only" to calculate and send one-dimensional FEC data.

Select "Column and Row" to calculate and send two-dimensional FEC

data.

Number of columns (L): Enter number of columns.

Number of rows (D): Enter number of rows.

Note: Please note that the maximum matrix size is 256 (L*D) and

that D is in the range 4 ≤ D ≤ 32. In column only mode L is in the

range 1 ≤ L ≤ 32, while in column and row mode 4 ≤ L ≤ 32. L+D can

not exceed 32.

Note: Please note that FEC column packets are transmitted on UDP

port n+2 and FEC row packets are transmitted on UDP port n+4

where n is the UDP port of the media data. This is in accordance

with Pro-MPEG CoP 3.

Skew: Controls whether to organize the column FEC with or without

skew. When enabling skew, the delay required on the receiver is less

than when transmitting straight columns.

FEC overhead: This number is the overhead in percent caused by the

current FEC configuration.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 92 93

Brak uwag

Network Technologies ASI-IP-GTW Instrukcja Użytkownika Strona 42